Check-mate tool

[cubalibre000]

Hi,
I'm looking for a checker that verify the presence of error in assembly constraints.
Someone has built this test ?

Check-mate tool need some particular license type ?

Thank you...

Using NX 8 and TC8.3

 

[JohnRBaker]

If your NX license was a MACH bundle then there's a very good chance that you already have a Check Mate license. So give it a shot and see what happens.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[uwam2ie]

@John,
there is no OOTB Check for asm constraint problems in NX8-
or am I wrong?

 

[JohnRBaker]

You are correct. However, work is underway to add those additional tests and they will be included as enhancements in a future release of NX.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.