Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
Checking Gauge - Bushing/Hole Identification
- Thread starter AeroTD
- Start date
EdStainless
Materials
Nope, no std for sequence or order for these things.
We always did go/go-no first and grouped by size.
Since often a part will have a lot of holes of one size this made sense.
The hardest ones to check were either first or last, depending on the devices used.
Work with the people that will be checking them, see what involves the fewest changes of tools and positions.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, consulting work welcomed
We always did go/go-no first and grouped by size.
Since often a part will have a lot of holes of one size this made sense.
The hardest ones to check were either first or last, depending on the devices used.
Work with the people that will be checking them, see what involves the fewest changes of tools and positions.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, consulting work welcomed
- Status
Similar threads
