Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Checking of drawings

Status
Not open for further replies.

bruwel

Petroleum
Jul 14, 2011
37
I seem to remember, from a previous job, that there is an ASME document defining good checking procedures. I can't find any references to them online though. Am I nuts? Or am I looking in the wrong hidey hole?
Thanks
 
Replies continue below

Recommended for you

I don't think there's an ASME std relating directly to it. However, you could look over in GD&T forum at some of the checking posts over there, for instance:

thread1103-151962
thread1103-193286
thread1103-167827
thread1103-216008
thread1103-305732


Drafting zone used to have a piece about checking and what should be checked etc - I thought there was a link to it in one post or another. I think the Genium manual which is linked to drafting zone also has some stuff.

Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor