Checkmate customized rules 3

[man2007]

NX installation comes with predefined Checkmate rules, e.g. checking if Sketches are fully constrained or not. I want to create custom checkmate rules. Can someone guide me in this regard. Requesting to share couple of examples, if possible.

 

[SiW979]

Customising check mate is quite difficult, you need to be conversant in KF, I have attached some customised checks and other bits and bobs if it is of any use.

Cheers

Si.



Best regards

Simon NX7.5.4.4 MP8 - TC 8

http://www.jcb.com

 

[man2007]

Thank you very much JCBCAD for the valuable information!!!