Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Chimney is Separating From a House 3

Status
Not open for further replies.

cap4000

Civil/Environmental
Sep 21, 2003
555
Does anyone have any structural experience on inspecting a chimney which is separating badly from a house. Typically it is a settlement or undersized footing related issue when the gap is very large say 3/4 to 1 inch. Perhaps storm drainage runof in the chimney area and lumber framing from a gable roof may also be contributing to the chimney leaning. Any tips or feedback will be greatly appreciated.
 
Replies continue below

Recommended for you

Last year, a client's house had numerous problems including a chimney separation. The cause turned out to be a combination of the house's foundations heaving because of expansive soils and tree root intrusion in addition to chimney settlement caused by an overloaded footing.

In this photo the chimney is seen "falling away" (toward the right). Notice that even though this chimney is connected to the brick veneer, it is taking that part of the wall with it.

ChimneyFailure.jpg


[idea]

[r2d2]
 
Might look into installing pin pile under the chimney and jacking it up to level.

Whatever the reason, most likely related to downspouts or foundation drains though, the problem causing the separation needs to be identified and remedied.

Mike McCann
MMC Engineering
 
Jike:

Looks like you took a page from the new Ebay bestseller "How to Remove Your Chimney in One Easy Lesson".

[nosmiley]

Mike McCann
MMC Engineering
 
Since the masonry veneer was strong enough to remain intact and distribute the lateral chimney displacement the length of the wall, there may also be a problem with the connection of the veneer to the back-up. Since masonry theoretically has little tensile or flexural strength, the ties may be inadequate. - This could also be a typical builder practice that is on all of the walls.

Dick
 
Dick,

The OP did not include a photo. I think your comment is about SlideRule's photo, which I think he posted just for interest.
 
I admit the mistake. SlideRuleEra's photo is certainly a classic problem for uncontrolled residential construction.

Sorry for cluttering up the site/problem.

Dick
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor