Circles show up w. segments - how to avoid this?

[remko]

In Solidworks, when I extrude / cut from sketches with circles (perfect circles in the sketch), the 3D result shows clear circle segments. How can I avoid this?

 

[Arlin]

Tools
Options
Document Properties
Image Quality

 

[macPT]

I some of my recent projects, which include structures mesuring 4-5meters long, some curves/holes have a poor graphic representation, even pulling the Image Quality slide to its maximum. This did not happen in the smaller components/assemblies that I used to design.

Can I force it to a better value (an alternative to the slide maximum position)?

Regards

 

[SBaugh]

The slide is the only way to adjust your Image quality in SW.

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376