Circular imprint

[ChrisHadfield]

Hi everyone,

I have used circular imprint in NX-9 fem builder. After a couple of operations I would like to edit these imprints and/or suppress them. I don't find how to do so, can someone help me on that?

thank you

 

[Toost]

I have no clue on what this is, have you created circular faces on a FEM model, for loads/ boundary conditions ?
If so, you need to make the _I.part the work part to edit/suppress. ( You can find it in the top of the Simulation navigator)

Or ?

Regards,
Tomas