enggasw
Mechanical
- Aug 14, 2023
- 2
Hey all,
I was undergoing a project where I had to incorporate two pneumatic cylinders for up and down linear motion, at the top it is connected with an epoxy plate with pins, it supposed to move in a linear motion along with the cylinder to set the pins with pads. In this process after all the proceeding we had a problem of the pins not moving in a straight line, the linear movement is somewhere having a tilt while actuating, we couldn't be able to figure out why we get that tilt even there we had four guide shafts at the four corners along with linear bearing. Could anyone guide me to figure out the issue in it.