Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Clearance between Ceramic Spool & Ceramic Cage

Status
Not open for further replies.
Doppe

Doppe

Industrial
Mar 16, 2004
4
I'm trying to find out the clearance that would typically be used between the Spool and Cage of a Ceramic 3/2 Spool Valve that would be used in water service of upto about 300PSI.

The Spool OD is 10mm at the moment. The ports in the Cage(Sleeve) are 2mm Diameter with the Spool "Over-Lapping" by 0.2mm.

Any help would be greatly appreciated ...
 
Status
Not open for further replies.

Similar threads

Eng.Husky
  • Locked
  • Question
Difference between working pressure and ceiling pressure in asme b16.34
Replies
1
Views
257
PeterIgg
PeterIgg
MattBoss
  • Locked
  • Question
Aerospace Butterfly Valves with relative angle between disc and shaft
Replies
0
Views
179
MattBoss
MattBoss
skengg
  • Locked
  • Question
VALVES & PIPE FITTINGs COMPLIANT TO AUSTRALIA NEW ZEALAND WSWA GUIDELINE CODE.
Replies
0
Views
138
skengg
skengg
yamoffathoo
  • Locked
  • Question
How does a 8" Crane 465.5 Gate Valve Stem Separate ? (cast iron gate & manganese bronze ste
Replies
4
Views
309
yamoffathoo
yamoffathoo
bryansonnier
  • Locked
  • Question
Acceptable Clearance with Backup Ring
Replies
1
Views
51
hydtools
hydtools

Part and Inventory Search

Sponsor

Back
Top Bottom