Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Clicking anything sends into update loop

Thread starter jpate92
Start date May 1, 2015

Status: Not open for further replies.

May 1, 2015

jpate92

Automotive

Hey all,

I get the feeling this might just be a needed NX restart but I figured I would ask before we lose the work that hasn't been saved.

I have a user who, any time they try to do anything in their assembly it goes into a 10 minute update loop of all the components. Is this a know issue and is there a way to get out of this loop?

Thanks!

John Pate