Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

*CLOAD with Orientation

Status
Not open for further replies.

rideway

Mechanical
Nov 23, 2009
15
Hello everybody

I would like to know if its possible to apply a CLOAD with a given orientation.

By using DLOAD I can give a predefined orientation, but i would like to use a concentrated load. Is it possible?

If not, what is the best way to apply a 200N load to a defined nodeset? Creat a surface an use DSLOAD or simply DLOAD? In this case, which load type should I use?

Thanks a lot in advance!
 
Replies continue below

Recommended for you

Anyone could please help me? I am still stucked with this problem...
Thanks in advance!

Regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor