Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Closed Drain system

Thread starter fergalom
Start date Nov 15, 2001

Status: Not open for further replies.

Nov 15, 2001

fergalom

Mechanical

I am looking for info on how to design a closed drain system for draining natural gas filter separators. It would be very helpful to see a general P&ID if available. The spearators need to drain to a high pressure receiver vessel (Knockout drum). Finally this receiver is to be drained to a low pressure holding tank. Any info / pointers on the design of the vessels or a supplier (Europe)
Cheers