TedT
Mechanical
- Oct 20, 1999
- 32
Does anyone have experience with a Oakite Duo Kote 58 which is 10% by wt. phosphoric acid, 50% mineral oil, 10% glycol ether, 5% water, balance neutral. I am coating this on sheet steel used for stamping.<br>
Can you recommmend a coating thickness, coating method, i.e. roll, airless spray etc. What is your experience?<br>
Did you need a dryer?
Can you recommmend a coating thickness, coating method, i.e. roll, airless spray etc. What is your experience?<br>
Did you need a dryer?