Hi
I am looking to create cohesive elements in NX Simcenter 3D.
I don't want to look at the cohesive layer between plies in a laminate
I want to look at the cohesive/ bonded joint in-between two different surfaces that are attached e.g foam to skin.
I am using Simcenter 3D Multiphysics Environment (with a SOL401/402), and I am trying to use the 3D Swept Mesh command with the Type list set to Manual Between to create the elements with CHEXCZ elements.
I am struggling to get the elements created and there is no online tutorials of how to create these elements.
Does anyone have any information on how to create these elements and run a model ?
Kind regards
I am looking to create cohesive elements in NX Simcenter 3D.
I don't want to look at the cohesive layer between plies in a laminate
I want to look at the cohesive/ bonded joint in-between two different surfaces that are attached e.g foam to skin.
I am using Simcenter 3D Multiphysics Environment (with a SOL401/402), and I am trying to use the 3D Swept Mesh command with the Type list set to Manual Between to create the elements with CHEXCZ elements.
I am struggling to get the elements created and there is no online tutorials of how to create these elements.
Does anyone have any information on how to create these elements and run a model ?
Kind regards
