Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Coil Break Defect in Cold-Rolled Steel

Status
Not open for further replies.

Salvatio

Materials
Joined
Oct 10, 2003
Messages
62
Location
MY
Dear all,

Recently we are facing several coil-break defects in our Skin Pass Mill. We were told that the discharge temperature from our Batch Anneallers is too high. However, it was maintained within below 40degC, yet we still found coil break at random coils. Uncoiling speed at SPM is already near to its maximum (especially for thick gauge strip). In addition, we dont have S-roll in our SPM, just deflector roll prior to work-roll. Could it be that the uncoiling angle being too high, which cause the coil-break? Thanks for your replies
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top