Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Column tray thickness and width

Status
Not open for further replies.
MMiyan

MMiyan

Mechanical
Dec 11, 2014
9
IN
Dear Sir,

Please suggest the thickness and width of internal tray support ring for column to design
 
Replies continue below

Recommended for you

Sort by date Sort by votes
In inches; 2" x 2" x 3/16" angle iron, installed "Leg out & Leg Down". Further, use these tray rings as vacuum stays in the vessel calculations. You will find that a Full Vacuum rating is available.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

daily123214
  • Locked
  • Question
Minimum Thickness with changing radius
Replies
2
Views
13
daily123214
daily123214
Lorenzo Loreto
  • Question
API 650 Tank Rebuild - Type and quantity of weld inspections 1
Replies
4
Views
54
JStephen
JStephen
Water_Guy
  • Locked
  • Question
API 579 - MAT and temperature reduction
Replies
2
Views
39
Water_Guy
Water_Guy
maceca
  • Locked
  • Question
Where, how and when i must use doub
Replies
2
Views
24
LittleInch
LittleInch
arbitrader
  • Locked
  • Question
Wind Overturning and Sliding of API-650 Tank
Replies
1
Views
19
HTURKAK
HTURKAK

Part and Inventory Search

Sponsor

Back
Top