Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Column Width in SW BOM's

Status
Not open for further replies.

g60dude

Mechanical
May 26, 2006
17
Using SW 2004 and its SW's driven BOM. Is there a way to get the column width narrower. I see how once the BOM is in the drawing, you can clic on one of the edges of the column you can drag the width a little. But there is still quite a bit of empty space between the column edge and the letters. I want the letters to be right up agains the column edge.

Thanks
 
Replies continue below

Recommended for you

Not sure about SW04 but in SW06 you can adjust the Cell Padding in the Table Format section of the BOM properties.

[cheers]
Helpful SW websites faq559-520​
How to find answers ... faq559-1091​
SW2006-SP5 Basic ... No PDM​
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor