Nella95
Mechanical
- Nov 21, 2005
- 400
What steps should I follow in setting up a comparitive study in COSMOS? (Or is there somewhere on the web, or tutorials, etc. - that outline that procedure.)
Basically I have one design - a flat piece of sheet metal in an assembly -and I've set up another configuration and in that flat part's place, I have another design.
PS, I'm pretty sure my replacement design is favorable, depending on cost, so I already know the results I want.
Basically I have one design - a flat piece of sheet metal in an assembly -and I've set up another configuration and in that flat part's place, I have another design.
PS, I'm pretty sure my replacement design is favorable, depending on cost, so I already know the results I want.