Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Compensation for springback for stamping die surfaces

Thread starter jmvPE
Start date Sep 3, 2006

Status: Not open for further replies.

Sep 3, 2006

jmvPE

Mechanical

Does anyone use CATIA V5 to fully compensate die surfaces? We have found it not as easy as other software, but the "robust" and "knowledge" based capabilities of V5 make it seem like something worth investigating.

Any past stories or direction would be helpful.

Also, has anyone used ThinkDesign and CATIA V5 together? Any translation or logistical problems?