Component Array in NX 9.0

[nithinv]

Hello Mates,

I just upgraded to NX9.0 from NX8.0 and could not fine "Create Component Array" there. Instead, there was "Pattern Component" which I tried to use. I was able to complete one circular component array with out any warnings, but once I complete the command, I could not find patterned components either in screen or assembly tree. In assembly navigator, one circular array was appeared under a title "Components Pattern" but it shows some warning symbol (yellow triangle with exclamatory mark). Even if I place my mouse pointer on that it does not pop up any warning.

Please help how to do this correctly....

Thanks in advance,
Nithin.V

 

[JohnRBaker]

Without seeing at least what your Assembly and the Component Pattern looks like, as well as how the Assembly Navigator shows the Pattern, there's not much that anyone could say about what the issue(s) might be.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.