DonovanP
Automotive
- Jul 29, 2021
- 1
Good day everyone.
I'm working in NX12.0.2.9
The last couple of days I've had the issue that when I select a sub-assembly in an assembly, each component in the sub-assembly is highlighted item by item.
This is "slightly" frustrating when attempting to move a engine around in an engine bay.
I have encountered this before but cannot for the life of me remember how to fix it.
I'm working in NX12.0.2.9
The last couple of days I've had the issue that when I select a sub-assembly in an assembly, each component in the sub-assembly is highlighted item by item.
This is "slightly" frustrating when attempting to move a engine around in an engine bay.
I have encountered this before but cannot for the life of me remember how to fix it.
