Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Composite position tolerance control frame

Thread starter SeasonLee
Start date Jul 30, 2011

Status: Not open for further replies.

Jul 30, 2011

SeasonLee

Mechanical

I am using AutoCAD 2010, there is no problem to draw a position toleranc feature control frame, but how to draw a composite position tolerance (one position symbol with two levels tolerance), and how to draw two single segment position tolerance controls.

Thanks for all helps

SeasonLee