Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Compress Saddle Design vs PV Elite

Thread starter carljpme
Start date Apr 29, 2014

Status: Not open for further replies.

Apr 29, 2014

carljpme

Mechanical

I am cross checking a PV Elite saddle design output from a vendor using Compress and the PV Elite output is accepting a much larger load without overstressing the saddle. Compress is checking the saddle horn (S4) and the saddle wear plate (S4) but it appears that PV Elite is only checking the saddle horn (S4). Can anyone give me some feed back on this issue?