SloFlo
Mechanical
- Sep 11, 2006
- 39
Does anybody have experience doing compressor washes on units which have a shaft driven atomizing air compressor.
I am concerned that water will get sucked into the compressor and damage it.
One solution that I am considering is placing a valve in the 6" line to the compressor. However, this might damage the compressor also because it will have no suction yet it will still be rotating.
Does anybody have any experience with this or suggestions on how to do this properly?
Thank you
I am concerned that water will get sucked into the compressor and damage it.
One solution that I am considering is placing a valve in the 6" line to the compressor. However, this might damage the compressor also because it will have no suction yet it will still be rotating.
Does anybody have any experience with this or suggestions on how to do this properly?
Thank you