Configurations-Design Tables with Tolerance

[macduff]

Hello,
I have a bearing design with 2 configurations. The only difference is the ID has a different size and tolerance. What I'd like to know is how display the tolerance in design table and to display the tolerance with different values for the same dimension.

I have the dimension set for "This Configuration Only" for both configurations and successful in creating a design table. The only help I need is with the tolerance to show up in the design table, and to have different tolerance values for that dimension. I hope I'm clear with my question.


Thanks,

Macduff
Meggitt Airdynamics Inc.
Dell Precision 370
SW2004 Pro SP4.1
XP Pro SP2.0
NIVIDA Quadro FX 1300

 

[CorBlimeyLimey]

I don't believe dimension tolerances can be driven from a DT.
Time for an Enhancement Request?

& all the best.

 

[rporter]

You can drive the tolerance from a DT in 2005

I believe it was not untill 2005 that you could even set up differant tolerance for a dim based on configuration.

 

[macduff]

Thanks for your help fellas.

Best,

Macduff
Meggitt Airdynamics Inc.
Dell Precision 370
SW2004 Pro SP4.1
XP Pro SP2.0
NIVIDA Quadro FX 1300