Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Conical Hole

Status
Not open for further replies.

xcaos

Mechanical
Nov 3, 2002
6
Can anybody tell me how to make an conical hole?

Thank you.
 
Replies continue below

Recommended for you

There are several different methods...

Centerline and tappered profile that you revolve-cut.

Cut-extrusion with an applied draft.

It realy depends on what the design intent is and what are the governing factors for the conical hole. Ray Reynolds
Senior Designer
Ricon Corp. faq731-376
 
If you are making a countersunk hole, try the "Hole Wizard" Gravity is a harsh mistress.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor