Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Contacts in ANSYS Workbench

Thread starter franjm
Start date Nov 19, 2013

Status: Not open for further replies.

Nov 19, 2013

franjm

Industrial

I Would like to understand the differences of use between the contacts of ANSYS Workbench.

I don´t know how to use the correct contact (Bonded, No separation, frictionless, rough, frictional, forced frictional sliding)

Could anybody help me?

Thanks