Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Contour surfaces

Status
Not open for further replies.
Cubicaltrauma

Cubicaltrauma

Mechanical
Aug 26, 2009
1
I am just trying to figure out what the best way is to do some extracts from a contour surface in R18.

Any help is appreciated.
 
Status
Not open for further replies.

Similar threads

jzecha
  • Locked
  • Question
Error Extracting Surfaces from a Search
Replies
8
Views
104
jzecha
jzecha
Eisengrindt
  • Locked
  • Question
Creating a pad on inclined side surfaces
Replies
2
Views
92
Wuzhee
Wuzhee
Sriram V
  • Question
Finding Layup location in a tool by comparing surfaces in catia v5
Replies
0
Views
148
Sriram V
Sriram V
DiaeArrahmane
  • Locked
  • Helpful tip
CATIA MACRO: Offset of multiple Surfaces
Replies
0
Views
53
DiaeArrahmane
DiaeArrahmane
Wuzhee
  • Locked
  • Question
Can I draft these two surfaces?
Replies
7
Views
55
Wuzhee
Wuzhee

Part and Inventory Search

Sponsor

Back
Top Bottom