Control Points on surfacing

[engmechs]

Hi all,
Can someone point me a direction how to set control points on surfacing (such as Blend boundaries)? I checked my textbook, & stuff, but didn't say too much on it.

Thanks in advance.

engmechs

 

[JohnAndrews]

How about "Suggested Technique for Creating a Surface from Boundaries Using Blend Control Points"

http://www.ptc.com/cs/cs_24/howto/suf55/suf55.htm

The PTC Knowledge Base is pretty useful, and is always the first place where I look if I have any problems with Pro/E:

http://www.ptc.com/appserver/cs/search/search.jsp

 

[engmechs]

Thanks very much John,
I can't access the first website... lost my password .... can you send this page to me?

Regards,

engmechs