Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Controlling text size of ID symbols with Annotation editor

Thread starter MickyV007
Start date Oct 26, 2009

Status: Not open for further replies.

Oct 26, 2009

MickyV007

Mechanical

When working with ID symbols on a drawing you often encounter that the text (with date) is to big for the ID symbol.

You can control the size of the text in the ID symbol by using the annotation editor like in the example attachment.

Hope this was usefull.

Best regards,

Michäël.

NX4.0.4.2 MP10 / TCE 9.1.3.8_build_0711 / NX6.0.2.8 / NX7.0.0.9

Belgium