NirVidP
Industrial
- May 10, 2010
- 45
Is the procedure for naming Properties in SolidWorks documented anywhere. I have searched help and web but was unable to find any.
For example:
"SW-Cost-StockType@food_processor.SLDASM"
What does the part before and after @ means.
Sometimes there are more than 2 strings separated by @
Sometimes there are more than 2 @ symbols together.
Its all confusing.
Where can I get info about this?
For example:
"SW-Cost-StockType@food_processor.SLDASM"
What does the part before and after @ means.
Sometimes there are more than 2 strings separated by @
Sometimes there are more than 2 @ symbols together.
Its all confusing.
Where can I get info about this?