Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

conversion ABAQUS 6.12 to 6.10

Status
Not open for further replies.

afefdridi

Mechanical
Jan 31, 2011
72
Hello everybody


Can i convert my model done in abaqus 6.12 to abaqus 6.10? Is it possible to do or not thanks a lot

also what are the fortran, abaqus and visual studio compatible to each other

thanks a lot
 
Replies continue below

Recommended for you

Hi,


If you have an .inp file you should be able to import your model into v6.10. If you just have a .cae file you may need to upgrade.

Dave
 
thanks dave for your response

i have the .inp file but would you please tell me how do i proceed exactly thanks a lot
 
Hi,

Open Abaqus/CAE and go to File -> Import Model. In the menu that pops up change the File Filter Type to "Abaqus Input File (*.inp,*.pes)". Navigate to the folder where you stored your .inp file, select it and press OK. Abaqus/CAE should read your input file and recreate the model in v6.10.

Read "Section 10.8: Importing a Model" in the Abaqus/CAE manual for more info.

Good luck,
Dave
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor