BobSoW
Mechanical
- Jun 21, 2003
- 1
Is there a way to convert all groups into blocks?
Group names can be used as blocknames.
Regards Bob.
History behind the question.
We went from Logocad to Autocad Mechanical 2004. Converting Logocad drawings (group oriented) to AM 2004 goes well until you start adding mechanical parts.
During saving AM 2004 crashes. Autodesk is saying that groups are conflicting with the structuur of Mechanical.
Group names can be used as blocknames.
Regards Bob.
History behind the question.
We went from Logocad to Autocad Mechanical 2004. Converting Logocad drawings (group oriented) to AM 2004 goes well until you start adding mechanical parts.
During saving AM 2004 crashes. Autodesk is saying that groups are conflicting with the structuur of Mechanical.
