Converting Autodesk Inventor Assembly (.iam)

[SiW979]

We have been sent an assembly in the format above which we need to imprt into NX4. Apparently this is some sort of Step file, however we cannont import it. Would anyone know what I need in order to convert this type of assembly?

Many thanks in advance

Best regards

Simon NX4.0.4.2 MP10 - TCEng 9.1.3.6.c - (NX6.0.3.6 MP2 native)

http://www.jcb.com

Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...

 

[somo2424]

Can i open INVENT file(.prt, iam)????
IF it can, what's a wonderful things!!!
Sorry.^^
i'm beginner of NX..

 

[eex23]

To somo2424:
No, directly you can not open inventor files. Some time ago we also had some deal with autodesk inventor files. We asked company which made these files to convert them into the step format. Then there were no problem to import them into the nx4.

 

[looslib]

The Inventor .iam file is the assembly file that holds the component pointers, like a Pro/E .asm file.

Simon, I have inventor and NX4. send me an email at: ben<dot>loosli<at>ge<dot>com


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli