Converting directory from mm to inch

[hexfly]

Hi. Did something change on 7.5?

I am converting an assembly from mm to in. using the convert part utility.

at the prompt I type in ug_convert_part -in -d C:\0-Main\Designs\customer\1756\1756 Design

I get an error saying that there are too many parts in the directory. This is how I have always done it. What am I doing wrong?

Thanks.
Adam

 

[hexfly]

Never mind. I needed to change the directory name to 1756_Design.
It needed the underscore...

Feel free to delete this post.
Thanks anyhow.
adam