Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Converting dxf file to an ascii file used by a simulation tool

Thread starter gnmpcmx1
Start date Oct 22, 2001

Status: Not open for further replies.

Oct 22, 2001

gnmpcmx1

Industrial

I am very interested on knowing how I can convert a dxf file ,obtained from a GIS, to an ascii file. I will use this ascii file into a simulation tool. This ascii file should have information about diameter, length, x, and y coordinates.

Would you be so kind as to give me hand to solve this problem?