Converting Sketch Point to Datum points

[NTME76249]

Is there a way to convert sketch points to datum points to be used in piping?


Michael McMillan

http://www.linkedin.com/pub/michael-mcmillan/53/375/52b

http://cadtechie.blogspot.com/

 

[mjcole]

Right Click hte sketch points and select Geometry option instead of Construction which is what the point type is if they do not show as PNT#s on screen.
This can be Toggled back and forth just like Reference and Driving Dimensions can as long as you are in Wildfire 5 Point 0 or greater (Creo #.#) etc.

For Dimensions with Equal Relation E1 E1, E2 E2 set you can convert the dimension E# symbol you want to be a driving dim to a strong dimension and convert the previous driving dim to be Reference in much the same way.

Geometry <--> Construction
Driving <--> Reference

"It's not the size of the Forum that matters, It's the Quality of the Posts"

Michael Cole
Boston, MA
CSWP, CSWI, CSWTS
Follow me on !w¡#$%
@ TrajPar - @ mcSldWrx2008
= ProE = SolidWorks

 

[RBobroski]

Wow, I didn't know you could do that. Been using the program for three years now. This helps immensely, thank you.