coolant / water separator

[Judge]

Hello,

In our Machining Dept. we use a water soluble coolant ( cutting fluid ). We would like to reduce the cost of disposal of the used coolant by removing the water content which is approx. 94%. Does anyone know if there is a separator available which can remove the water clean enough to put in the drain.

Thank you

 

[dcasto]

There may be a mole sieve or charcol bed that could work. You could also do distillation. You might state what the material is so a larger audiance can help you.

 

[cub3bead]

Is your water soluble coolant Trim?Sol, Blaso?Cut, Cimcool or something similar? If it is then an ultrafilter will be capable of reducing the water content of the waste coolant.