Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Copy Part reference into a new drawing - Without ruining the pos. order

Thread starter Mekanikles
Start date May 4, 2015

Status: Not open for further replies.

May 4, 2015

Mekanikles

Mechanical

Ok, this have bugged me for awhile.

When I copy the Part references from one drawing to another the pos. numbers always get scrambled up in the Part list. Is there any way to copy them and still keep the original pos. numbering?

Thanks in advance!

"If you're not part of the solution, you're part of the problem" - John McClane,Die hard