Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations Toost on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

copy paste

Thread starter wildbill47
Start date Nov 1, 2007

Status: Not open for further replies.

Nov 1, 2007

wildbill47

Mechanical

I find it difficult to use Microsift Project I knew trouble was not far off when asked to create a "fancy Gantt chart", it's useless other than impressing the higher-ups but i have run into an issue on 2003 what is the problem I'm having when I copy and paste a new task from a similar one and try to set new start dates...how can I break this link? is copy paste not permissible? 419-239-8800