COPYING master models

[GPowers2]

people,

Teamcentre 9.1.2.10
NX4 4.0.4.2 MP6

as you would expect we COPY Master Models to new identities many times .... I have users who forget to uncheck a current dialogue that copies the Drawing along with the Master Model.... thus I end up with the same specification being allied to two different Master Models .....
? - where would I find the user setting that would allow me to have unchecked by default ...

thanks in advance .....
gary

 

[SiW979]

Unless you have access to your custom defaults, then you will need to speak to one of your NX/TCEng administrators, but have a look at some of the setting within the customer defaults as shown in the image attached to this thread. One of them may work.

Best regards

Simon (NX4.0.4.2 MP4 - TCEng 9.1.3.6.c)

http://www.jcb.com

Life shouldn't be measured by the number of breaths you take, but rather how many times it's taken away...