cordinates Missing

[in2010in]

Hi

For example take a rectangular block having 4 holes or slots on 4 sides like B0, B90, B180, B270...I generated program B0 is main Remaing all "LOCAl" but Special Output I used "USE MAIN MCS" bcoz my work offset(G55) same for all 4 sides.
My program verification shows everything perfect , But when I post the nc output at B180 side "Z" values appering in "Y" , "Y" values appering In "Z" so how to change this.

And also I am not getting "B" value in my out put at B180 side.

Just see pic what I attached.
pls help me how to comeout .
soory for my English yaa

Thnks
UGNX6

 

[cadcamnx]

use only main
not use local

andre...

specialist and multi axis
development of IS & V
and postprocessors
member committee nxcam plm world
skype:andrenxcam7