Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Corner forming for sheet-metal enclosures

Status
Not open for further replies.

nigelt

Mechanical
Jan 10, 2003
50
CA
thread820-326262

This may be of interest to folks trying to form tidy sealed corners.

A local vendor has this machine, the only drawback is that each corner shape (that is radius and wall height) requires a specific rolling tool. So, unless your supplier has a family of tools available to which you can match/adapt your design, you will have to pony-up for "your" tool. However, the results are exactly as illustrated.

It doesn't exactly answer the needs of the original posting but might be helpful to be aware of.

"You will master any feeling of inadequacy you may be having"
....from my fortune cookie @ the buffet!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top