Corner symbol

[saarp]

Hi.

I've been looking for a way to make a "undefined corner symbol" like in ISO 13715
Example can be seen here:

http://www.en.technisches-zeichnen.net/technical-drawing/basics-02/edge-informatinos.php

Thank you in advance.

 

[NutAce]

Just create it in Drafting as it should be and make a custom symbol out of it...
How to create a custom symbol (re-use library) you can find in the helpfiles.

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5

HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5

 

[saarp]

There is no standard symbol for that?

 

[NutAce]

nope

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5

HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5

 

[jerry1423]

Here is something close that you can cut and paste into your annotation editor
<U><+>-0,2<U>

 

[cowski]

If the symbol is part of the ISO standard and NX doesn't support it, you should contact GTAC and open an enhancement request (ER). This way, the symbol could be fully supported in a future version of NX.

www.nxjournaling.com

 

[saarp]

Jerry,
Thank you - it's quite good enough for now

Cowski,
I'm surprised it's not already in the standard symbols. Anyway we don't have direct access to Siemens so we need to do it through the local representative (complicated...)

 

[jerry1423]

One my drawing the line width of the vertical line was thin, but using edit -> object display I was able to make it thicker

 

[PatelJignesh]

Hi,

Create sketch and make symbol out of this.
Check attached DWG.



Thanks,
Jignesh Patel
(NX9/TC10)
L&T Technology Services