extrudedfeature
Mechanical
- May 16, 2012
- 24
Hello All,
I am struggling to find the most useful way to dimension two holes that extend from an angled surface. I have a wedge shape, with holes extending from the flat bottom, and two extending down from the top angled surface (see image attached.
What would be the best way to show the location of these holes, should I be adding a drawing view that is turned so that the angled face is now parallel?
Many Thanks in advance
I am struggling to find the most useful way to dimension two holes that extend from an angled surface. I have a wedge shape, with holes extending from the flat bottom, and two extending down from the top angled surface (see image attached.
What would be the best way to show the location of these holes, should I be adding a drawing view that is turned so that the angled face is now parallel?
Many Thanks in advance