Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CosmosFloWorks 05 and lofting

Status
Not open for further replies.

tha89sx

Automotive
Jun 13, 2007
40
CA
I am looking for some tips regarding configuring a hollow tube that has a number lofts for use in Floworks 05. No matter how I configure the "Lids/caps" for each end I always run into the dreaded error that the object does not exist in the fluid boundry when creating boundry conditions.

At first I figured this was due to the feature having an odd inlet that was not 'normal' to the incoming air. So I built a flange and I still had problems.

Any help is appreciated.



 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top