Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

COSMOSfloworks always crashes when doing a study

Status
Not open for further replies.

josephv

Mechanical
Oct 1, 2002
683
CA
Hello all,

Hope all is great.

I am teaching an FEA course at a local college and noticed that all the student machines have this problem.

1) Open a part or assembly in SolidWorks
2) Run the Floworks study wizard
3) Name the study and select next
4) The window where one selects the type of study freezes
5) SolidWorks crashes

Has anyone run into this problem before? I reported this to the IT group and they will most likely contact the reseller, but was wondering if anyone had any suggestions.

cheers,

Joseph
 
Replies continue below

Recommended for you

OK, the IT group contacted SolidWorks and they said that there is a conflict with FloWorks 2008 and AutoCAD Mechanical (i.e. it only occurs in machines that have both of these installed). This problem is fixed in FloWorks 2009 (i.e. it will work in all machines).
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top