Mar 25, 2005 #1 israelkk Aerospace Dec 30, 2002 2,280 0 0 IL Is there a Cosmosworks version which will work inside Solidworks 2000? If the answer is yes what is the Cosmosworks version?
Is there a Cosmosworks version which will work inside Solidworks 2000? If the answer is yes what is the Cosmosworks version?
Mar 26, 2005 #2 jxc Mechanical Nov 6, 2002 25 0 0 US Israelkk, The easist way to answer that question is to contact a solidworks rep or use the website http://www.solidworks.com. I am sure there is with that version of solidworks, most likely named the same. Good luck, jxc Upvote 0 Downvote
Israelkk, The easist way to answer that question is to contact a solidworks rep or use the website http://www.solidworks.com. I am sure there is with that version of solidworks, most likely named the same. Good luck, jxc
Mar 27, 2005 Thread starter #3 israelkk Aerospace Dec 30, 2002 2,280 0 0 IL jxc I tried to look at theirsites but could not find any info for previous versions of Solidworks just for the current version of Solidworks. Upvote 0 Downvote
jxc I tried to look at theirsites but could not find any info for previous versions of Solidworks just for the current version of Solidworks.
Mar 29, 2005 #4 hiyer Mechanical Nov 26, 2003 18 0 0 US I think COSMOSWorks 6.0 was the version for SW 2000. It's going to be very difficult if you are trying to obtain that version and its license. Upvote 0 Downvote
I think COSMOSWorks 6.0 was the version for SW 2000. It's going to be very difficult if you are trying to obtain that version and its license.
Mar 29, 2005 Thread starter #5 israelkk Aerospace Dec 30, 2002 2,280 0 0 IL hiyer Thanks, I assumed so too because I have seen reference to Version 7 for Solidworks 2001. Upvote 0 Downvote