COSMOSXpress

[lakewood]

hi,
I am having problem when I want to run Cosmosxpress.
Getting a mesage "the specified module could not be found",
could not load SolidWorks DLL:cosworks.dllu.dll, the add in selected is not a valid SolidWorks Add-In.
Also, I am not able to save SW part as sat file-getting similar message "the specified module coud not be found and so on.

Can enyone help???

Thanks!

 

[CorBlimeyLimey]

Try turning off the anti-virus & do a repair of SW. If that doesn't work, go to the FAQ section at top of this page & work through the applicable Solidworks Installation section.