Counterbored hole drill size.

[rollupswx]

I'm following PTC Academy tutorial. In the upper portion of the attached image I show the Tutorial views and in the lower portion I show my setting the same, except that I cannot get access to the through hole drill size?

The only way I have found to get around this is to turn off Add Tapping, but that is not what the tutorial shows?

Am I missing something?

In any case it seems to me that if you select Counterbore hole that the default behavior should be to go to a clearance hole rather than a tapped hole.

Wildfire 4

 

[rollupswx]

This is the only way I have been able to get the desired sizes.

 

[dgallup]

In your config.pro file set

hole_diameter_override yes

 

[rollupswx]

In your config.pro file...

I must have missed that step in the beginner tutorial...

 

[dgallup]

You have to master config options to master Pro/E...

 

[rollupswx]

You have to master config options to master Pro/E...

I'll get there. That is if I don't toss my computer out the window in frustration over variable section sweeps, blends... ...where is my Loft tool, ahhhhh